• For pressing into 30 mm ø x 11.5 mm drilling
• Rear panel at least 16 mm thick
• Load capacity: 15 kg / each in accordance with EN 15939 in test frame A
• Lateral alignment ± 8 mm
• Suspension with suspension hook ø 6 x 50 mm
• Die-cast zinc, galvanised

Information on load capacity of cabinet suspension brackets and on accessories
The following basic loading principles must be observed when using cabinet suspension brackets and accessories:

• Both the furniture design and the quality of the furniture's material and production are beyond our control.
• The quality and condition of wall materials are also beyond our control.
• The suspension hooks we supply must be used with wall plugs and are intended for attachment to solid brick, solid sand lime brick, concrete or engineering brick. An 8 mm hole must be drilled into the wall, with the plastic wall plug being knocked in to leave it flush with the surface. The hook must be screwed into a depth that leaves at least 10 mm of its length projecting from the wall.
• Commercial type special mounting elements must be used for attachment to other wall materials.
• Dowels and screws must be matched to one another. Ordinary chipboard screws must not be used instead of wall plug screws.
• Mounting suspension rails:
  - with 2 special screws ø 5.5 x 50 mm near each cabinet suspension bracket
  - from a cabinet body width of 900 mm, an additional special screw, ø 5.5 x 50 mm, must be fitted at the centre on the back of each cabinet body (type A, type B and type H).
• Add on elements, such as end shelves, must not be fitted without separate cabinet suspension bracket.
• The cabinet maker / dealer is responsible for ensuring that the furniture which is placed on the market meets with the requirements of EN 14749.