Suspension rail, type H with reinforcing edge, 350 mm | 1076496 | eShop Hettich - Your leading manufacturer of furniture fittings

Suspension rail, type H with reinforcing edge, 350 mmArticle Number 1076496

For cabinet suspension brackets SAH 215 and SAH 216
Load capacity 150 kg / cabinet
Attachment:
- with 2 special screws ø 5.5 x 50 mm near each cabinet suspension bracket
- from a cabinet body width of 900 mm, an additional special screw, ø 5.5 x 50, must be fitted at the centre on the back of each cabinet body
- use special fixing screws
With oblong holes
steel galvanised

Advice:

Suspension rail with slip off protection; on adjusting the position of the wall unit it cannot slip off the suspension rail and fall!
Please order fixing screws separately

Information on load capacity of cabinet suspension brackets and on accessories
The following basic loading principles must be observed when using cabinet suspension brackets and accessories:

Both the furniture design and the quality of the furniture's material and production are beyond our control.
The quality and condition of wall materials are also beyond our control.
The suspension hooks we supply must be used with wall plugs and are intended for attachment to solid brick, solid sand lime brick, concrete or engineering brick. An 8 mm hole must be drilled into the wall, with the plastic wall plug being knocked in to leave it flush with the surface. The hook must be screwed into a depth that leaves at least 10 mm of its length projecting from the wall.
Commercial type special mounting elements must be used for attachment to other wall materials.
Dowels and screws must be matched to one another. Ordinary chipboard screws must not be used instead of wall plug screws.
Mounting suspension rails:
- with 2 special screws ø 5.5 x 50 mm near each cabinet suspension bracket
- from a cabinet body width of 900 mm, an additional special screw, ø 5.5 x 50 mm, must be fitted at the centre on the back of each cabinet body (type A, type B and type H).
Add on elements, such as end shelves, must not be fitted without separate cabinet suspension bracket.
The cabinet maker / dealer is responsible for ensuring that the furniture which is placed on the market meets with the requirements of EN 14749.