SAH 305 for installation in rear panel | 40669 | eShop Hettich - Your leading manufacturer of furniture fittings

SAH 305 for installation in rear panelArticle Number 40669

For pressing into 30 mm ø x 11.5 mm drilling
Rear panel at least 16 mm thick
Load capacity: 15 kg / each in accordance with EN 15939 in test frame A
Lateral alignment ± 8 mm
Suspension with suspension hook ø 6 x 50 mm
Die-cast zinc, galvanised

Information on load capacity of cabinet suspension brackets and on accessories
The following basic loading principles must be observed when using cabinet suspension brackets and accessories:

Both the furniture design and the quality of the furniture's material and production are beyond our control.
The quality and condition of wall materials are also beyond our control.
The suspension hooks we supply must be used with wall plugs and are intended for attachment to solid brick, solid sand lime brick, concrete or engineering brick. An 8 mm hole must be drilled into the wall, with the plastic wall plug being knocked in to leave it flush with the surface. The hook must be screwed into a depth that leaves at least 10 mm of its length projecting from the wall.
Commercial type special mounting elements must be used for attachment to other wall materials.
Dowels and screws must be matched to one another. Ordinary chipboard screws must not be used instead of wall plug screws.
Mounting suspension rails:
- with 2 special screws ø 5.5 x 50 mm near each cabinet suspension bracket
- from a cabinet body width of 900 mm, an additional special screw, ø 5.5 x 50 mm, must be fitted at the centre on the back of each cabinet body (type A, type B and type H).
Add on elements, such as end shelves, must not be fitted without separate cabinet suspension bracket.
The cabinet maker / dealer is responsible for ensuring that the furniture which is placed on the market meets with the requirements of EN 14749.

Hettich CAD